 Fluke Loop Testers |
 |
Fluke 705 Loop Calibrator
The new Fluke 705 Loop Calibrator is a
cost-effective, integrated solution for calibration,
repair and maintenance of current loops. It
features: mA sourcing, simulation and measurement
0.02% accuracy and 0.001 mA resolution. Simultaneous
mA and % of span display Selectable step or ramp
outputs 24 V Loop supply with mA measure
|
 |
Fluke 707 Loop Calibrator With
Quick Click Knob
The Fluke 707 Loop Calibrator is a high performance
solution for calibration, repair and maintenance of
current loops. The new "Quick Click" knob making it
extremely fast and easy to use.
|
 |
Fluke 707EX Intrinsically Safe
Loop Calibrator
The 707Ex is an intrinsically safe loop calibrator
for use in explosion endangered areas. The Fluke
707Ex is certified in accordance with the ATEX
directive (Ex II 2 G Eex ia IIC T4) in Zones 1 and
2.
|
 |
Fluke 715 VOLT/mA Calibrator
The Fluke 715 Volt/ mA Calibrator delivers
outstanding performance, durability and reliability.
Offered in the rugged Fluke 80 Series DMM package,
the calibrator is compact, lightweight, and easy to
carry. With a push button interface similar to the
multifunction Fluke 740 Series Documenting Process
Calibrators, the 715 is easy to use.
|
 |
Fluke 771 Milliamp Process Clamp
Meter
Measure 4-20 mA signals without breaking the loop
with this new, compact clamp meter for PLC and
control systems analogue I/O. The detachable clamp
with extension cable allows you to take measurements
in tight locations, and the built-in spot light
illuminates hard to see wires in dark enclosures.
|
 |
Fluke 787 Process Meter
A maintenance and calibration tool that will be at
home in every instrumentation technician's tool box,
the Fluke 787 ProcessMeter™ combines a DMM and a
Loop Calibrator in one rugged, handheld tool, for
about what you would expect to pay for a loop
calibrator alone.
|
 |
Fluke 789 Process Meter With 250
OHM Hart Resistor
The Fluke 787 was the first tool to combine a DMM
and a loop calibrator to give process technicians
double the power in one tool. Now it’s even better,
the range is extended with the new Fluke 789 – the
ultimate loop calibration multimeter.
|
 Kyoritsu Loop Testers |
 |
4116A/4118A
Custom microprocessor controlled for highest
accuracy and reliability. • 3 LEDs for checking
correct wiring status. • 15mA LOOP measurement:LOOP
impedance 2000ΩO range measurement is carried out
with low test current (15mA).The current will not
cause tripping out involved RCD even the one with
the lowest nominal differential current (30mA). •
Direct reading of Prospective Short Circuit Current
(PSC). (4118A only)
|
 |
4120A
Custom microprocessor controlled for highest
accuracy and reliability. • 3 LEDs for checking
correct wiring status. • 15mA LOOP measurement:LOOP
impedance 2000ΩO range measurement is carried out
with low test current (15mA). The current will not
cause tripping out involved RCD even the one with
the lowest nominal differential current (30mA).
|
